Relay high/low beam Axel Joost Mini

Axel Joost load relay Mini: this electronic load relay has 2 outputs, each can be loaded with 60W and takes over the switching from low beam and high beam via push button. The size of this load relay fits into any lamp. The 2 outputs can be connected in parallel via an additional programming cable so that 1 output with 120W can be switched. The outputs of the mini load relay can be loaded up to 6A each: short-circuit-proof and limit at 15A.

Features:

• dimensions: width 47mm, thickness 15mm
• current consumption: max 7mA without power unit
• casing: black ABS plastic with black Odopal casting resin
• input voltage: 7-16V
• connections: control part 0.5mm², power part 1mm², each length 10cm
• max operating temperature: 100°C
• admissible current from 12V connection: 5Ampere continuous current
• short-circuit proof

Connections:

• red: thin keys or switch input, thick +12V supply voltage
• yellow: both outputs switch simultaneously if cable is bridged to ground
• green: the load relay only works with light switch if cable is bridged to ground
• blue: the dipped beam is switched off once the ignition is switched on
• violet: output low beam and high beam
• black: ground

Note! Do not install near the ignition system.