Electronic box version C with 1 handlebar adapter: the C-Box is available with 1 handlebar adapter (C-1), or 2 handle bar adapters (C-2). It controls the main electrical functions with push buttons on your motorcycle from a central location. The universally applicable digital cable harness version C (The C stands for Communication ...) for key control goes a revolutionary new way: a small control box on the handlebar, available with 1 handlebar adapter and a small control box on the rear part of the bike take over the entire control of the bike and "talk" through a thin serial line. The load cables to the consumers are wired by the closer box. As a result, various cable meters are saved, the load lines to the consumers are shorter and the installation time is drastically reduced in a rebuild.
The Electronicbox provides the following functions:
An adapter on the handlebar will be connected to the push buttons and a thin single cable connects the adapter to the electronicbox. 8 status led, connected to the outputs allow an easy installation and control. The most functions can be changed without problems from the user. Just hold the horn button while switching on the 12V and the box is in the program mode after release the button; a short flash will indicate this status. You can change the function pressing the left or right indicator button. You change to the next programm mode with an additional press on the hornbutton; the indicators will flash 2 times in order to show you the status. The indicators will flash 2 times in order to show you the new program option. The functions are written in the E-Eprom and can be changed to every time. Please note that you need to switch off the box for minimum 3 seconds in order to discharge the internal capacitors before you can change the settings again.
If you do not find the answer, please ask us a question.
Your question has been forwarded to our staff, we will notify as soon as will respond to your question.